|
 Wayne
Drake has been a mechanical engineer by profession since 1973. He has an
extensive background in advanced mathematics and engineering graphics. He
received his Bachelor of Science degree in Mechanical Engineering from Georgia
Institute of Technology in Atlanta, Georgia in December 1972 and his Master of
Science degree in Aeronautical Systems Engineering from the University of West
Florida in 1976. His interest in cutting and installing crown molding and trim
stems from his many years as a woodworking hobbyist. The event that led to the
founding of www.compoundmiter.com (March 2000) was the
construction of six of the large birdfeeders shown on his website and in Chapter
16 of his book. While making these as Christmas presents, he discovered after
cutting all 24 gazebo roof pieces, the birdfeeder plans had the wrong miter and
blade tilt angles. He then sat down and graphically derived what is now called
the Compound Miter Chart© (pages 51 and 52) which illustrates the relationship
between corner angle and crown slope angle for a compound miter cut. Today, www.compoundmiter.com is the best and only one-stop-source for information on how to cut any compound
miter angle.
Contact Mr. Drake
for any questions.
Crown Molding &
Trim: Install It Like A PRO!
Email - Wayne@CompoundMiter.com
1-866-544-2016
(toll free)
Or
1-850-651-8262
|
